MTP 15HD RS Series • Setup Guide
This card provides quick start instructions for an experienced installer to set up and operate any of the MTP VGA video and RS‑232 transmission
systems.
Unjumpered for
One-way (Default)
Pre-installation — RS-232 Jumper
The receiver’s RS‑232 circuits are factory‑set to be one‑way, transmitter to receiver. If the system has only one
receiver, jumper JMP 1 on the main board can be set for two‑way communication as shown at right.
JMP3
JMP2
JMP1
Installation
Step 1 — Mounting
Jumpered for
Two-way
Turn off or disconnect all equipment power sources and mount the MTP transmitter and up to eight receivers
as required.
RS-232
Tx Rx
Step 2 — Transmitter Inputs
•
•
•
Connect a computer (VGA) video source to the Input connector.
Connect a VGA monitor to the Monitor connector.
Plug an RS‑232 device into the RS‑232 port. Wire the connector as shown below.
INPUT
MONITOR
Tx
Rx
Receive
Transmit
Ground
Connected
RS-232
Device Pins
Pins:
12345678
MTP
Pins
T568A
Wire Color
T568B
Wire Color
Gnd
Pin
1
White-green
White-orange
2
3
4
5
Green
Orange
Step 3 — TP Cables Between Units
White-orange
Blue
White-green
Blue
•
Terminate a TP cable as shown at right. Connect it between the transmitter’s Output port and the
receiver’s Input port (both ends must match).
White-blue
White-blue
6
7
8
Orange
Green
White-brown
Brown
White-brown
Brown
Insert Twisted
Pair Wires
NOTE: If the unit is labeled “C7,” only CAT 7 cable should be used.
NOTE: If you are using Enhanced Skew-Free™
A/V cable, use the TIA/EIA T568A standard only.
•
For daisy-chaining, connect up to eight TP cables between a receiver’s Buffered
Output port and a daisy‑chained receiver’s Input port.
RS-232
Tx Rx
Step 4 — Receiver Outputs
•
•
Connect a VGA monitor to the Output connector.
Plug an RS‑232 device into the RS‑232 port. Wire the connector as shown in step 2, above.
OUTPUT
Step 5 — Receiver DIP Switches
•
•
H Sync and V. Sync switches — Set these switches up for positive sync or down for negative sync.
ON
Composite Sync, (SOG), and Video switches — Set these switches as shown in the following table to output the
indicated format.
1
2
3
4
5
6
Output Format
C Sync
SOG
Video
RGBHV
RGBS
RGsB
Component*
S‑Video*
Composite*
NOTE: * Input video format must match.
•
End Unit switch — Set this switch up if either of the following is true:
•
•
The receiver being configured is the only receiver connected to the transmitter.
The receiver being configured is the last receiver in a daisy‑chained system.
|
Dyson Vacuum Cleaner DC18SAOP User Manual
Earlex Paint Sprayer HV7000 User Manual
Everpure Water System CGCC 1 User Manual
Excell Precision Pressure Washer VR2300 User Manual
Fisher Paykel Sleep Apnea Machine HC230 User Manual
Fisher Price Bouncy Seat B8865 User Manual
Fluke Thermometer 80t 150u User Manual
Garmin Car Stereo System 695 User Manual
GE Air Conditioner AEE08AK User Manual
Globalsat Technology GPS Receiver BU 303 SiRF II BU 353 SiRF III User Manual